Activity 5.1 Calculating Properties of Shapes


Activity 5.1 Calculating Properties of Shapes





Conclusion
1.      What is the difference between a circle and an ellipse?
 In the circle the center point is equidistant to the circumference while it's not for ellipse.




2.      What is the difference between an inscribed and a circumscribed shape?
 Inscribed shape is inside circle while touching circumference of circle while circumscribed shape is outside of circle while touching circle's circumference.




3.      Why is it impossible for a triangle to contain a 180° angle?
 Because a triangle need 3 angles and only can have total of 180 degrees. Hence an angle occupying all the degrees lead to only an angle instead of triangle.




4.      How is a rhombus similar to a square?

 Rhombus and square both has 2 pairs of parallel sides, 4 sides,  and 4 angles.


5.      What is the difference between a right, acute, and obtuse triangle?
Acute triangle has angles under 90 degrees. Right triangle has 90 degress angle. Obtuse triangle has angle above 90 degrees.

Comments

Post a Comment

Popular posts from this blog

Activity 5.6 Physical Property Analysis

Image
Activity 5.6 Physical Property Analysis Questions for Aluminum Object One Directions: Complete the calculation by hand. Show all work below and select the appropriate answer based on your calculations. Check your work using the 3D modeling software. If your answers differ, explain why you think they are different where appropriate. 1.       What is the volume of the part? A.      1.875 in.³ B.      1.125 in.³ C.     1.375 in.³ D.     2.125 in.³ SHOW WORK:                  2.                                                    ...
Read more

Activity 5.5a CAD Model Features Part 1

Image
Activity 5.5a CAD Model Features Part 1 Conclusion 1.          What 3D CAD functions could be used to create a wire coat hanger? We can use sweep after drawing line and circle for thickness of wire on a plane starting. 2.          For each of the following, sketch a 2D shape and an axis of rotation that you could use to model each of the following solid forms using the Revolve function within 3D modeling software. Dimension each sketch and indicate the axis of rotation that you would use. You may use software to check your answers. a.          A solid cylinder with a diameter of 3.5 in. and a height of 7 in. Be sure to dimension the shape. Dotted line is axis of rotation. b.          A solid sphere using the Revolve function. What rotation angle would you use? ...
Read more

Activity 3.1b Linear Measurement with US Customary Units

Image
Activity 3.1b Linear Measurement with US Customary Units Procedure Conclusion 1.                   When you look at a drawing, how do you know if you are looking at U S Customary or SI measurements? Why is it important for an engineer to know this piece of information? US customary system has fractions. Moreover SI measurements are only in power of tens while US customary system is not. Engineers need to know this information or else they will end with the wrong measurements, which leads to  too little or too large designs.
Read more