Project 9.3 Virtual Design Challenge Day 4 Hr 5

Project 9.3 Virtual Design Challenge Day 4 Hr 5
https://drive.google.com/file/d/1WxIFfGPzNCkCJowQDX77RBERaggAU6O8/view?usp=sharing
tolerances all done with drawing.

Comments

Post a Comment

Popular posts from this blog

Activity 5.6 Physical Property Analysis

Image
Activity 5.6 Physical Property Analysis Questions for Aluminum Object One Directions: Complete the calculation by hand. Show all work below and select the appropriate answer based on your calculations. Check your work using the 3D modeling software. If your answers differ, explain why you think they are different where appropriate. 1.       What is the volume of the part? A.      1.875 in.³ B.      1.125 in.³ C.     1.375 in.³ D.     2.125 in.³ SHOW WORK:                  2.                                                    ...
Read more

Activity 3.1b Linear Measurement with US Customary Units

Image
Activity 3.1b Linear Measurement with US Customary Units Procedure Conclusion 1.                   When you look at a drawing, how do you know if you are looking at U S Customary or SI measurements? Why is it important for an engineer to know this piece of information? US customary system has fractions. Moreover SI measurements are only in power of tens while US customary system is not. Engineers need to know this information or else they will end with the wrong measurements, which leads to  too little or too large designs.
Read more

Activity 9.1 Product Lifecycle

Image
Activity 9.1 Product Lifecycle Conclusion 1.       What is meant by product lifecycle ?  Product life-cycle is the process in which the object designed by engineer goes through. 2.       Why is it important for companies who make products to research and determine a product’s potential lifecycle?  This is important to determine the sources of material for product and to change the factory place in accordance with bulk-gaining or bulk-reducing industry. As well as the duration the product will be used by each person and to ensure its proper disposal. 3.       What would you change about your product? Why?  I think the product should be changed to be more tough. Because we didn't do a structural integrity test yet. As well as assembling by more interlocking wood joint. 4.       Do you think your product will evolve or become obsolete over t...
Read more